Safety Instructions

When setting up your printer
When choosing a place for the printer
When using the printer
When handling photo cartridges
Warnings, Cautions, and Notes

Read all of the instructions in this section before using your printer. Also, be sure to follow all warnings and instructions marked on the printer.

When setting up your printer

Observe the following when setting up the printer:

  • Do not block or cover the vents and openings in the printer.

  • Power supply cords should be placed to avoid abrasions, cuts, fraying, crimping, and kinking. Do not place objects on top of power-supply cords and do not allow the AC adapter or power-supply cords to be stepped on or run over. Be particularly careful to keep all power-supply cords straight at the ends and the points where they enter and leave the AC adapter.

  • Use only the AC adapter model A251B/E that comes with this product. Use of another cord may result in fire or electrical shock, or injury.

  • The AC adapter is designed for use with the printer with which it was included. Do not attempt to use it with other electronic devices unless specified.

  • Use only the type of power source indicated on the AC adapter's label, and always supply power directly from a standard domestic electrical outlet with the AC power cord that meets the relevant local safety standards.

  • Avoid using outlets on the same circuit as photocopiers or air control systems that regularly switch on and off.

  • Avoid using electrical outlets controlled by wall switches or automatic timers.

  • Keep the entire computer system away from potential sources of electromagnetic interference, such as loudspeakers or the base units of cordless telephones.

  • Do not use a damaged or frayed power cord and AC adapter.

  • If you use an extension cord with the printer, make sure that the total ampere rating of the devices plugged into the extension cord does not exceed the cord's ampere rating. Also, make sure that the total ampere rating of all devices plugged into the wall outlet does not exceed the wall outlet's ampere rating.

  • Never disassemble, modify, or attempt to repair the AC adapter, power cord, printer, and option by yourself except as specifically explained in the printer's guides.

  • Unplug the printer and the AC adapter, and refer servicing to qualified service personnel under the following conditions:

The power cord or plug is damaged; liquid has entered the printer or the AC adapter; the printer or the AC adapter has been dropped or the casing damaged; the printer or the AC adapter does not operate normally or exhibits a distinct change in performance. (Do not adjust controls that are not covered by the operating instructions.)

  • Do not use with wet hands.

  • If you plan to use the printer in Germany, the building installation must be protected by a10 or 16 amp circuit breaker to provide adequate short-circuit protection and over-current protection for this printer.

Note for German-speaking users:
Bei Anschluss des Druckers an die Stromversorgung muss sichergestellt werden, dass die Gebäudeinstallation mit einer 10 A- oder 16 A-Sicherung abgesichert ist.

For United Kingdom, Singapore, and Hong Kong users

  • Replace fuses only with fuses of the correct size and rating.

Safety Requirements

Mains plug:
Use a 3-pin mains plug that is registered with the Safety Authority.

Flexible cord:
Use a double insulated flexible cord that is certified* to the relevant IEC standards.

Appliance connector:
Use an appliance connector certified* to IEC 320.

*  certified by member of IECEE CB Scheme.

For United Kingdom users

The following safety information applies to the AC adapter.

  • Warning: Refer to the rating plate for the voltage and check that the appliance voltage corresponds to the supply voltage.

  • Important: The wires in the mains lead fitted to this appliance are coloured in accordance with following code: Blue - Neutral, Brown - Live

If you have to fit a plug:

  • As the colours of the mains lead of the appliance may not match the coloured markings used to identify the terminals in a plug, please observe the following:

  • The blue wire must be connected to the terminal in the plug marked with the letter N.

  • The brown wire must be connected to the terminal in the plug marked with the letter L.

  • If damage occurs to the plug, replace the cord set or consult a qualified electrician.

When choosing a place for the printer

Observe the following when choosing a place for the printer:

  • Place the printer on a flat, stable surface that extends beyond the base of the printer in all directions. If you place the printer by the wall, leave more than 10 cm between the back of the printer and the wall. The printer will not operate properly if it is tilted at an angle.

  • When storing or transporting the printer, do not tilt it, stand it on its side, or turn it upside down. Otherwise, ink may leak from the cartridge.

  • Leave enough space in front of the printer for the paper to be fully ejected.

  • Avoid places subject to rapid changes in temperature and humidity. Also, keep the printer and the AC adapter away from direct sunlight, strong light, water, or heat sources.

  • Avoid places subject to dust, shock, or vibration.

  • Leave enough room around the printer to allow for sufficient ventilation.

  • Place the printer near a wall outlet where the plug can be easily unplugged.

Note for French-speaking users:
Placez l'imprimante près d'une prise de contacte où la fiche peut être débranchée facilement.

  • Do not place or store the printer or the AC adapter outdoors.

When using the printer

Observe the following when using the printer:

  • Do not insert objects through the slots in the printer.

  • Take care not to spill liquid on the printer and the AC adapter.

  • Do not put your hand inside the printer or touch the photo cartridge during printing.

  • Do not move the print head by hand; otherwise, you may damage the printer.

  • Always turn the printer off using the On button. Do not unplug the printer or turn off the power to the outlet until the power light goes out.

  • Before transporting the printer, make sure that the photo cartridge is in place.

  • Leave the photo cartridge installed. Removing the cartridge can dehydrate the print head and may prevent the printer from printing.

When handling photo cartridges

Observe the following when handling photo cartridges:

  • Keep photo cartridges out of the reach of children. Do not allow children to drink from or otherwise handle the cartridges.

  • Do not shake photo cartridge after removing it from the bag; this can cause leakage.

  • Be careful when you handle used photo cartridges, as there may be some ink remaining around the ink supply ports. If ink gets onto your skin, wash the area thoroughly with soap and water. If ink gets into your eyes, flush them immediately with water. If discomfort or vision problems continue after a thorough flushing, see a doctor immediately.

  • Do not remove or tear the label on the cartridge; this can cause leakage.

  • Install the photo cartridge immediately after you remove it from its package. If you leave a cartridge unpacked for a long time before using it, normal printing may not be possible.

  • Do not use a photo cartridge beyond the date printed on the cartridge carton: otherwise, it may result in reduced print quality. For best results, use up the photo cartridge within six months of installing it.

  • Do not dismantle photo cartridges or try to refill them. This could damage the print head.

  • After bringing a photo cartridge inside from a cold storage site, allow it to warm up at room temperature for at least three hours before using it.

  • Store photo cartridges in a cool, dark place.

  • Do not touch the green IC chip on the bottom of the cartridge. Doing so may prevent normal operation and printing.

  • The IC chip on the photo cartridge retains a variety of cartridge-related information, such as the amount of ink remaining, so that the cartridge may be removed and reinstalled freely. However, each time the cartridge is inserted, some ink is consumed because the printer automatically performs a reliability check.

  • If you remove the photo cartridge for later use, protect the ink supply ports from dirt and dust and store it in the same environment as the printer. A valve in the ink supply ports makes covers or plugs unnecessary, but the ink may stain items that come into contact with this area of the cartridge. Do not touch the ink supply ports or the surrounding area.

  • Store each photo cartridge so that the bottom of its packaging faces down.

ENERGY STAR® Compliance

As an ENERGY STAR® Partner, Epson has determined that this product meets the ENERGY STAR® guidelines for energy efficiency.

The International ENERGY STAR® Office Equipment Program is a voluntary partnership with the computer and office equipment industry to promote the introduction of energy-efficient personal computers, monitors, printers, fax machines, copiers, scanners, and multifunction devices in an effort to reduce air pollution caused by power generation. Their standards and logos are uniform among participating nations.

Warnings, Cautions, and Notes

Warnings
must be followed carefully to avoid bodily injury.

Cautions
must be observed to avoid damage to your equipment.

Notes
contain important information and useful tips on the operation of your printer.