Safety Instructions

Warnings, Cautions, and Notes

Read all of these instructions and save them for later reference. Follow all warnings and instructions marked on the scanner.

  • Place the scanner close enough to the computer for the interface cable to reach it easily. Do not place or store the scanner outdoors, near excessive dirt or dust, water, heat sources, or in locations subject to shocks, vibrations, high temperature or humidity, direct sunlight, strong light sources, or rapid changes in temperature or humidity. Do not use with wet hands.

  • Place the scanner near an electrical outlet where the power cord can be easily unplugged.

  • Power-supply cords should be placed to avoid abrasions, cuts, fraying, crimping, and kinking. Do not place objects on top of power-supply cords and do not allow power-supply cords to be stepped on or run over. Be particularly careful to keep all power-supply cords straight at the ends and the points where they enter and leave the transformer.

  • Use only the type of power source indicated on the scanner's label.

  • Avoid using outlets on the same circuit as photocopiers or air control systems that regularly switch on and off.

  • If you use an extension cord with the scanner, make sure the total ampere rating of the devices plugged into the extension cord does not exceed the cord's ampere rating. Also, make sure the total ampere rating of all devices plugged into the electrical outlet does not exceed the electrical outlet's ampere rating. Do not place multiple loads on the electrical outlet.

  • Never disassemble, modify, or attempt to repair the power cord, scanner, or options by yourself, except as specifically explained in the scanner's guides.

  • Do not insert objects into any openings as they may touch dangerous voltage points or short out parts. Beware of electrical shock hazards.

  • Allow spaces behind the scanner for the cables, and space above the scanner so that you can fully raise the integrated TPU.

  • Unplug the scanner and refer servicing to qualified service personnel under the following conditions:
    The power cord or plug is damaged; liquid has entered the scanner; the scanner has been dropped or the case damaged; the scanner does not operate normally or exhibits a distinct change in performance. (Do not adjust controls that are not covered by the operating instructions.)

  • If you plan to use the scanner in Germany, the building installation must be protected by a 10 or 16 amp circuit breaker to provide adequate short-circuit protection and over-current protection for this scanner.

For German-speaking users:
Bei Anschluss des Scanners an die Stromversorgung muss sichergestellt werden, dass die Gebäudeinstallation mit einer 10 A- oder 16 A-Sicherung abgesichert ist.

For United Kingdom, Singapore and Hong Kong users:

If damage occurs to the plug, replace the cord set or consult a qualified electrician.

Replace fuses only with fuses of the correct size and rating.

For United Kingdom users:

Warning:
This appliance must be earthed. Refer to the rating plate for the voltage and check that the appliance voltage corresponds to the supply voltage.

Important:
The wires in the mains lead fitted to this appliance are coloured in accordance with the following code:
Green and yellow - Earth
Blue - Neutral
Brown - Live

If you have to fit a plug:
As the colours of the mains lead of this appliance may not match the coloured markings used to identify the terminals in a plug, please observe the following:

The green and yellow wire must be connected to the terminal in the plug which is marked with the letter E or with the earth symbol ().

The blue wire must be connected to the terminal in the plug marked with the letter N.

The brown wire must be connected to the terminal in the plug marked with the letter L.

Warnings, Cautions, and Notes

Warnings
must be followed carefully to avoid bodily injury.

Cautions
must be observed to avoid damage to your equipment.

Notes
contain important information and useful tips on the operation of this product.